1. Plug the Zapper into AC ("wall") power.

2. Verify that the Zapper receiver head is plugged into the Zapper body.

3. Select the button from your IR remote that you want the Zapper to recognize. (To teach the Zapper to recognize this IR     remote button, you will press it a total of eight times in the steps below.)

4. Press and hold the button on the receiver head for a few seconds until the LED lights green, then release the button.

5. While aiming the IR remote at the Zapper receiver head, press and hold the IR remote button until the green LED turns     off, then release the IR remote button.

6. After a short moment, the LED will re-light green. Repeat step 5 three more times.

7. After the above steps are completed, the LED will blink several times, then remain lit. Repeat step 5 four more times.

After the above steps are completed, the LED will pulse several times then go turn off. This indicates that
programming is complete.

The Zapper is now ready for normal use.