PCS2-K Steps

PCS-2 Kit Assembly Steps

		One lead of the LED is larger than the other to ensure that it can only be inserted into the PCB with the proper polarity.
		Pushbutton.
		220 Ohm resistor --red, red, brown gold color bands.
		10KOhm resistor -- brown, black, orange, gold bands.
		100 Ohm resistor -- brown, black, brown, gold bands.
		4.7 uF polarized capacitor. Note that the negative side marking of the capacitor goes to closest edge of the PCB.
		01.uF capacitor. Non-polarized, so it does not matter which way it is installed.
		Header pins.
		IR receiver. Insert the legs through the holes, then bend the receiver legs as shown.
		Note the orientation of the chip installation.
		Solder the brown and black twisted pair in these two holes. It does not matter which wire is in which of these two holes.
		Solder the red wire here.
		Solder the black wire here.
		Solder the purple wire here.

		There are 4 male Molex pins with 2 sets of wires connected to each. One set goes to a female connector. The other set are just bare, individual wires -- these are the ones that you will be cutting, stripping, and splicing.

		From left to right, cut the yellow wire and adjacent black wire as short as possible. Cut, strip, and tin with solder the other black wire and red wire.

		Strip and tin the loose ends of the black and red wires that you soldered to the PCS-2 board above.

		Solder the black and red wires from the last step to the red and black Molex pins as shown.

		Cut the included heatshrink tubing into 4 equal pieces.

		Heat shrink onto the bottom of the 4 Molex pins for proper insulation.

		To make inserting the wires properly, slide the empty Molex shell onto the Molex that already has wires inserted.

		Match the colors, and insert each of the pins until they click into place.

The final product.

Note that included in the kit is 3M double sided tape for mounting the PCS-2 inside the PC.